Anet ET4 · Igneus V2 (remix of Locos3D) · E3D V6

Toolhead with 4010 blowers and LED light

Every part starts laid out on the print bed, then lifts off and flies into place in assembly order. Then both LED strips and both blowers are wired in parallel: the fans start together, and 24 V reaches the four LEDs at the same moment.

Loading parts…
KitEvery part laid out on the bed
Drag to rotate · pinch to zoom
0.0 s
+ − 24 V +24 V GND Right strip Left strip

LEDs wired in parallel

Each strip segment carries its own resistor and runs straight from 24 V. Wired in parallel, all four LEDs get the same voltage, so they switch on together at the same brightness, and if one fails the others stay lit.

+ − FAN Part-cooling fan output GND 4010 right 4010 left

Blowers wired in parallel

Both 4010 blowers hang off the printer's part-cooling fan output. In parallel they get the same voltage and the same PWM, so they start together and always run at the same speed on both sides of the nozzle.

4010 right 4010 left 2510 hotend

Printed parts in black. The mod itself is the 4010 adapter, the LED mount and the 2510 fan adapter; the rest is the original Igneus V2. The fans are approximate models of the Ender 3 stock 4010 blower and the Kobra X 2510.